Operation Manual

Removal of the filter disk
In order to exchange the filter disk, open the acrylic disk
frame, as well as the door unit, with the filter disk (as
already described).
For the exchange of the filter disk, remove the inside
screws on the upper or lower locking plates of the filter
disk (fig 68).
Cleaning of the equipment
For the cleaning of the equipment use a damp cloth.
Do not use aggressive cleaning agents for lacquered
and decorative surfaces. A mild soap solution is
sufficient.
The acrylic disks have to be cleaned at regular intervals,
however are not compatible with some commercial
cosmetics and cleaning agents.
The compatibility ECOCLEAN has been tested, and can
be used without reservation.
We are not liable for damage of the acrylic disk by
chemical products of other manufacturers.
Support plate
(below)
Note:
The use of defective or non-specified filter disks can
lead to skin burns and must be avoided.
Only use original parts for replacement (observe article
number on the identification plate).
locking plate
inside screw
filter disk
Now you can remove the support profile and easily
remove the filter disk towards the front (Fig. 69)
The installation takes place in reverse order.
Fig. 68
Fig. 69
þ
53english