Operation Manual

45
Fig. 57
Fig. 58
Wiring
Transformer
Now mount the connecting cable to the upper bolt
(fig. 56).
The holding plates are pre-assembled with 3 screws
each and are provided with long holes, which are
needed for the adjustment of the door (fig. 55).
The adjustment of the door is absolutely required for
their function!
Adjust the door and tighten the screws.
Fig. 55
Fig. 56
Fig. 59
À Á
Â
The door is equipped with a back-lit decorative disk.
Install the enclosed transformer for the connection of
the door lighting, as well as for the wiring to the booth
(fig. 57, see also fig. 59, 60).
The booth is lit even during the time when the tanning
lamps are not in operation.
Three low-pressure halogen lamps 20 watts are
integrated in the ceiling (fig. 58).
The lamps are included in the shipment but are not
installed.
Make the plug connection to the lighting unit of the
cabin on the ceiling element (fig.59).
english