Operation Manual

Fig. 51

Assembly of the changing booth door

Install the connection cable at the lower door bolt (see

fig. 52).

You can choose whether the door shall be opened to

the left or to the right side. The required holding plates

are mounted factory-made.

The door is assembled as follows:

Now lift the door into the groove of the front-mounted

holding plate (fig. 53).

Lay down the door in front of the changing booth

(at the right hinge side, fig. 51).

Pivot the door as far as the upper holding bolt can be

mounted again (fig. 54). To do that, you have to lift the

holding plate a little.

Fig. 52

Fig. 53

Fig. 54

Attention:

Attach the plastics disk on the bearing bolt before you

insert the door. You find the disk in the accessory bag.

Holding plate

english