Operation Manual

Thereafter, screw the positioning bushing to the floor

plate (Fig. 34).

Following the installation of the fixed assembled parts

of the tanning booth (fixed segments, center column,

air exhaust unit) the assembly of the movable segments

takes place.

At first fasten the holding bushing of the upper bearings

to the air exhaust unit (Fig. 33).

Assembly of the movable door segments

Fig. 33

Holding bus-

hing

Then place the axial deep grove ball bearing on top

(Fig. 35).

If the door segments have been prepared as described,

they can now be installed.

Lift the door segment in its upright position, so that the

bearing bolt is touching the axial deep groove ball

bearing(fig. 37).

Then set the bearing bolt on the axial deep groove ball

bearing (Fig. 36).

Fig. 34

Fig. 37

Positioning

bushing

axial deep grove

ball bearing

Fig. 35

bearing bolt

Fig. 36

english