Operation Manual

If the ventilation unit is lying on the fixed segment, the

assembly holes in the holding bracket of the ventilation

unit have to align with those in the upper outside walls

of the fixed segments.

Fig. 25

Fasten the exhaust air unit with 2 screws (M10) per

holding bracket and 2 nuts (M10) to the fixed segments

(Fig. 25).

Fasten the hose with a hose clamp to the flange.

The exhaust air fitting for the exhaust air hose is pre-

assembled (Fig. 26).

(required hose = nominal diameter 400)

Fig. 26

Remove the loudspeaker on the inside of the of the

center column, in order to access the terminals for the

cable plug (Fig. 28).

After the mechanical connection of the fixed segments

to each other and to the air exhaust unit, the electrical

has to take place now.

Lay all connecting cables along the upper side of the

fixed segments to the center column.

Then these cables can be guided through the upper

opening in the center column (Fig. 27).

Assembly of the electrical connections

Fig. 27

Fig. 28

english