Operation Manual

Pivot the lamp frame into the fixed segment and fasten

with the provided Phillips head screw (Fig.23).

Make the electric connection for the venting (lower

terminal) in the inside area (Fig.22).

Then fasten the wires to the terminal.

Now pivot the lamp frame into the open position and

plan the electric connection for the UV-lamps (upper

terminals) in the inside area (Fig.21).

Fasten the wires to the terminals.

Fig. 21

Fig. 22

Fig. 23

Before you slide the ventilation unit on the front side onto

the fixed segments you have to make sure that all

electrical connection cables of the fixed segments are

hanging over the upper edge of the rear wall to the out-

side (Fig. 24).

Assembly of the exhaust air unit

Fig. 24

english