Operation Manual

Now insert the holding bushing into the assembly holes

and fix the fixed element with 2 socket head screws

M10 to the floor plate (fig. 12).

It is recommended that a second person supports the

previously fixed element until the next fixed element

(left or right) is installed.

After the second segment has been connected with the

floor plate, the segments are connected to each other

sideways (fig 13).

For this use the socket head screw M6, the appropriate

nut and the washer found in the enclosed package.

This assembly applies to all fixed elements.

Now lift the fixed segments into their position to align

the lower assembly holes with the holes in the floor

plate.

Installation of the fixed segments

Fig.12

Fig.13

Fig. 10

Fig. 11

Open the bolt lock and move the door into the open

position (fig. 9).

Now unscrew the bearing bolt at the bearing point

above (fig. 10).

Carefully lift out the door unit (fig. 11).

When putting down the door unit make sure that the

filter disks are not damaged.

english