Operation Manual

english32
Fixed Segments
For the assembly of the fixed segments it is
recommended to disassemble the disk or lamp
frame respectively.
With the high pressure elements it is
recommended to disassemble the filter disk
frame (see next page).
By this the attachment of the segments is made
considerably easier.
After you've taken out the disk frame in the individual
elements, you can now disassemble the lamp frame.
For this remove on the upper side of the segments the
attachment screw for the bearing bolt of the disk frame
(fig. 5).
The lower bearing bolt stays assembled.
Disassembly of the lamp frame
Disassembly of the disk frame
Open the disk frame.
Unscrew the upper and lower set screw until you
remove the disk frame to the side (fig 3 and 4).
Fig. 3
Fig. 4
Fig. 5