Operation Manual

30
l Finally, the posterior cover panel must be assembled
(Abb. 30).
l The opening limiter is pre-assembled to the door
segment. It must be bolted as shown in fig. 29.
Fig. 29
Fig. 30
l The floor covering should be fastened with the
enclosed glue dots (approximately 10, fig. 31).
You find the floor covering in package no. 4.
Fig. 31
posterior cover panel
Information on exhaust air ducting
The exhausted air of the unit should be removed from
the cabin through a hose. With regard to exhaust ducting
the following details should be observed.
The temperature of the surroundings decisively
influences the operation of the unit. The ideal
temperature is 28°C with a max. humidity of 70%.
The unit requires a hose of NW 400 mm (inside
diameter 375 mm.).
Both, diameter and hose ducting is very important.
Ideally, the hose should be ducted straight upwards from
the unit.
opening
limiter
Fig. 28
english