Operation Manual

6. Final assembly of the tanning segment
The required parts are in box no. 4.
l First reinsert the outside UV lamps and the acrylic
sheets into the fixed segments (see fig. 4).
Fig. 19
Fig. 20
Fig. 21
bottom plate
Fig. 22
english28
l First bolt the floor section body cooling to the base
panel (fig. 19).
To do this you need 2 clamping screws Ø 4x25 from
the accessories bag.
l Then fasten cover panel (which is in box no. 1)
with one screw each from top and from bottom (see
fig. 20 to 22).
Depending on model:
l Put the air duct in the specified space in the exhaust
air unit on the supply air nozzle.
l Fix the air duct with one screw at the top and at the
bottom.
Note: The upper screw point is in the big circular
hole of the exhaust air unit!