Operation Manual

25
l Check the position of the connection cables before
lifting the exhaust air unit onto the tanning segments
(fig. 10)
l Now lift the exhaust air unit onto the tanning
segments (fig. 11).
l Remove from the accessories bag 6 socket head
screws M10x30 and screw the exhaust air unit to the
tanning segments (fig. 12).
4. Assembly of the door segment
l The door segment is in box no. 1.
l First remove the acrylic sheet as described under 2
(also see fig. 4).
The upper and the lower bearing of the door have
been pre-assembled at the plant.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Axial grooved
ball bearing
M10x30
english
l The accessories bag contains a grooved ball
bearing.
l Place this onto the pre-assembled hinged panel
(fig. 13).