Operation Manual

24
l Now fasten the segment to the base panel. To do
this you need 2 socket head screws M10 x 30 from
the accessories bag (box no. 4).
l Bolt the element as shown in fig. 5. For the right
segment (box no. 2) follow the same procedure.
l Figure 7 shows the assembly work performed to this
point.
Please install the acrylic sheets now and pay
attention that the plastic guiding profiles are located
at the frontside towards the door area.
l Use the pre-assembled adjustment feet at the
bottom to adjust the two segments (see fig. 6).
3. Assembly of the exhaust air unit
The exhaust air unit is in box no. 4.
l Take the unit out of the box and remove the pre-
assembled operator's panel as it interferes with the
assembly of the exhaust air unit when left in place
(fig. 8 and 9).
Fig. 5
Fig. 7
Fig. 6
DIN 912
M10x30
Fig. 8
Fig. 9
Operator's panel during
assembly of exhaust air
unit in this position!
Operator's
panel
english