Operation Manual

The filter mat is fastened on the inner side of the housing
plate. Again, this is replaced simply by pulling away
from the adhesive surfaces.
Please note: Heavily soiled filter mats reduce the air
flow in the system and lead to excessive heating of
the appliance. Check the filter mats at regular intervals.
Cleaning of the tanning system
Use a moist cloth to clean the system. Do not, under
any circumstances, use harsh cleaning agents on
painted and decorative surfaces. A soap-and-water
solution is sufficient.
The acrylic plates should be cleaned at regular intervals.
Only solvent-free, non-caustic cleaners specifically
formulated for acrylic surfaces may be used for this
purpose.
threaded
fasteners for
base panel
foot end
sheet metal
housing plate
38 english