Operation Manual

To remove the lamp, grasp an outer, flattened end, push
it in the direction of the lamp end (longitudinally) and
pull it from the socket. Inserting the new lamp is
performed in the same manner.
Please note:
Do not touch the glass cylinder when removing or
inserting metal halogen lamps. Should this happen,
the lamp must be cleaned with pure alcohol or spirit.
Cleaning and replacement of the filter
plates in the high-intensity facial tanners
IIf it is necessary to clean the filter plates or replace
them due to damage, you must first fold down the acrylic
plate of the canopy and remove the face panel, as
previously described.
After you have removed the face panel, unscrew the
angle brackets on the outside. Now the filter plates can
be pushed out through the grooves on either side of the
face panel.
Please note:
The use of defective filter plates or plates not designed
for the specified system can result in burns to the skin
and is therefore to be avoided under any circum-
stances.
Use only original replacement parts (see equipment
model number on the identification plate).
The replacement of cleaned or new filter plates is
performed using the same procedure in reverse
sequence.
Adjustment of the tension spring system
The easy, low-friction swinging movement of the
canopy is ensured by the spring system integrated in
the foot-end sections on the right and left hand side.
The spring system is factory-adjusted to the
corresponding system model so that the canopy will
always remain in the open as well as in the closed
position as desired.
Should it be necessary, you may tighten or loosen the
springs using the threaded fastener for adjustment.
To this end you must first remove the base panel, as
described in the section on disassembly and
reassembly of the system.
angle bracket for
filter plates
face panel with
filter plate
36 english