Operation Manual

Maintenance
UV lamp and starter replacement
The UV lamps in your solarium must be replaced at
certain time intervals depending on the total number of
operating hours of the unit. The effective service life of
the low-pressure UV lamps as well as the metal halo-
gen lamps in the high-intensity facial tanners is
approximately 500-800 hours.
Please note:
When changing the UV lamps, use only the original
manufacturer's lamps specifically designed for the unit
model. You can order these from your customer service
department or local dealer using your unit's model
number (see model identification plate).
UV lamp and starter replacement in the
tanning bench
Open the tanning bench by unscrewing the threaded
fasteners (4 x special threaded fastener M4) on the left
and right bearing surface of the acrylic plate. Then
remove the bench acrylic plate frontally.
The UV low-pressure lamps are removed and replaced
by turning them 90° in their holders at the head and foot
ends. When inserting new lamps, make sure the contact
pins are securely inserted into the holders.
special threaded
fastener M4
acrylic plate, bench
34 english
The starters are located at the foot end of each lamp
and can be removed and replaced by turning them
90°.