Operation Manual

INSTALLATION GUIDE
The complete system is delivered on a pallet as
standard.
For transport of the system to its final location in the
cabin, it is necessary to disassemble the system partially
and to reassemble it at its destined position. (Notice:
Observe the following sequence of disassembly/
reassembly).
Also please ensure that both the transport route within
the studio as well as the final location within the cabin
are large enough to accommodate the system.
Recommended minimum cabin size 2.5 x 2.3 m
Please note that the electrical connection of the
system may be performed only by an approved
professional or certified electrician under observance
of the regulations of the VDE and the local power
supply utility.
Disassembly of the front base cover
Unscrew the threaded fasteners for the base panel on
both sides and remove the decorative caps.
Then pull the base cover forward and out.
Removal of the electrical plug-in module
All ballast units, compensators as well as the controls
for the system are integrated into an electrical plug-in
module, equipped with casters for mobility and located
below the bench.
Before you roll out the electrical plug-in module from
the front, you must place a provisional ramp in front of
the system at the same level as the transport pallet.
Now remove the transport locks of the electrical plug-
in module. Finally, the module under the bench is rolled
forward and out.
decorative
cap
threaded
fastener
front base cover
electrical unit
transport pallet
ramp
(provisional)
26 english
Now pull the electrical plugs of the canopy, the bench
and the rear side exhaust unit from the electrical plug-
in module.