Operation Manual

18
ON/OFF
FIG. 16
8.8.

Operation
The tanning unit will be switched on by using the On/
Off- switch
at the digital-timer.
With the keys
and
you can select your tanning
time (max. 30 minutes).
= up,
=down
After loose of time the digital timer of the tanning unit
switches off automatically. For cooling the tanning unit
the integrated fans are working for further 3 minutes.
For tanning units with facial lamps the digital timer has
to be switched on with key
.
The facial tanner achieves his full tanning capacity after
an exposure time of 3 minutes. After switching off and
immediate resetting the tubes ignite after 3 minutes
again.
Body cooling fan
For tanning units with body cooling you can switch
it on/ off with the key
at the digital timer.
Replacing the lamps and starters
Always switch off the power for the solarium before
performing any work on it!
Should a lamp fail to light up, take off the acrylic sheet. To
do so, take the cover off on one side of the unit. Then move
the acrylic sheet somewhat to one end, so that it becomes
free from the end cover.
The acrylic sheets have been placed with tension into the
grooves. To remove, simultaneously press the sheet to the
rear and down in the centre (up on the canopy) of the sheet,
and pull it out from the front groove as that edge will come
free first.
Now carefully turn the lamp backward or forward to
eliminate a possible contact fault. If this does not resolve
the problem, there may be a defect with the lamp or the
starter, which can be detected by either yourself or an
electrician:
Turn the lamp so that one of the bi-pins can be seen
through the lamp-holder groove. Take the lamp out carefully.
Replace the new lamp in the reverse manner. Then turn the
lamp by 90 degrees in the direction to where the writing on
the lamp is visible.
The defect could be in the starter, if the lamp assumed
faulty works in another lamp-holder. This can also be tested
by exchanging the starter. To do this, turn it to the left until
it comes free from its fixture. Turn the new starter to the
right.
Afterwards clean all lamps, the reflector and the acrylic
sheet with a soft cloth and replace the acrylic sheet.
english
Timer adjustment
jumper 1 (time period):
opened = maximum period 30 min
closed = maximum period 60 min
jumper 2 (fan delay)
opened = without fan delay
closed = with fan delay
jumper 2
jumper 1