Operation Manual

FIG. 11

ABB. 12

FIG. 14

FIG. 13

sotted hole

If the upper part does

not keep standing

above by opening,

please move the ball

pin forward.

If the upper part does

not keep standing

below by using, please

move the ball pin

backward.

To insure proper securing of the gas springs, the

canopy must be raised high enough so that the

upper ball-joint connector can be snapped onto the

ball-joint on the canopy.

Before depressing the canopy downward, the

securing clips on the ball-joint connectors must be

replaced to hold the ball-joints in place.

Replacement of the securing clips is very

important. The canopy

may not be depressed without this first being

done.

Move the canopy up and down a few times. You will

notice that when the canopy is completely raised,

the gas springs will move downward, a lighter

resistance will be noticeable than at lower levels.

Be advised, however, that slight variations in

resistance can occur. A lower or higher force variation

in the gas springs can influence the difficulty or

ease with which the canopy can be moved.

english