Operation Manual

17
english
Assembly of the Solarium
The assembly begins with the bench. Lift the bench
from the package and place it as shown in fig. 1, with
the lamps pointed down toward the floor. Use a blanket
or cloth underneath as protection. - Strips of cardboard
from the package may also be used.
Fig. 1
Machine front
2 x 4 pieces
loosen these
Screws
Fig. 2
Don't loosen these
screws
On the underside (this now points upward) the pedestal
is already secured at eight points. Take these screws out
and use them to secure to the pedestal feet. - Fig. 2
Fig. 3
Be sure that screws are fixed solidly.
Secure the profile-strip included in the accessories,
as in fig. 4, at toward the front of the feet. Use two 4.2
mm x 9.5 mm sheet metal screws do this.
Screws to
secure the
pedestal feet
Profile strip
Machine front
Fig. 4
Profile-
Strip
Fig. 5
Sheet metal screw
Situate the top edge of the front pedestal cover panel into
the groove underneath the forward bench rail. Be sure
that the side with the lightly grainy surface faces toward
the outside. Press the middle of the front pedestal panel
toward the inside until it clips into place.
The panel is strong enough and does not require being
screwed in.
Tanning programme
Depending on the skin type and the radiation source
integrated in your tanning appliance a tanning
programme was determined for your tanning appliance
according to the recommendations of DIN 5050 and EN
60-335-2-27. A sticker showing this tanning programme
is adhered to your tanning appliance (see figure on the
right).