Use and Care Manual

reached the set temperature. The heater will stop heating and initiate
component cooling process before turning off the fan. Once the desired
temperature is achieved, the heater will maintain the room to the set
temperature.
7. SETTING THE TEMPERATURE
Choose the desire Mode: ECO, HIGH, or LOW. To set the desired
temperature:
Press the button once
until the numeric temperature starts flashing.
Press the button again to increase the temperature or the button
to decrease the temperature.
Once the temperature is set, the heater will warm up the room using the selected
Mode. Heater will sample the room temperature every 4 minutes after the
desired temperature is reached.
8. Night Mode
Night mode is design for quiet operation in the night. You can press and hold
MODE button and then press button to set the night mode. The display
will show "ni". In this mode, when the heater reached the set temperature, it
will sample the room temperature less frequently, 30 minutes per sample.
Press and hold the Mode and then press button to cancel the night mode.
Display will show set temperature again
9. Display the room temperature
The display shows the set temperature all the time, press and hold the
MODE button and then press the button. The room temperature will
display for 30 seconds. It will return to set temperature after 30 seconds.
Remote Controller
HOW TO INSERT BATTERIES
NOTE: Remove the batteries if the remote control is not to be used for a month
or more. Batteries left in the unit may leak and cause damage.
DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX ALKALINE,
STANDARD (CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM)
BATTERIES!