Full Product Manual

Caution! Do not allow water to run
into the interior of the heater as
this could create a fire or electric
shock hazard.
4. The fan motor is factory-lubricated
for life and will require no further
lubrication.
5. Store the heater in a clean, dry
place when it is not in use.
Cleaning the electrostatic
filter
The heater has an electrostatic filter
located at the rear. The cleaning of
the filter should be performed once
per month or as needed (when dust is
visible on the filter) to ensure efficient
operation of the heater.
1. Power the heater OFF by pressing
the POWER button located on the
left side of the Control Panel.
2. Unplug the heater’s power cord.
3. Release the filter by pushing the
filter up from below (Figure 1).
4. Remove the filter by pulling down
and out (Figure 2).
5. Clean the filter by vacuuming.
6. Replace the filter by sliding the top
upwards into the spring loaded slot
on the back of the heater (Figure 2).
Then gently push the bottom of the
filter into place (Figure 1).
Warning: Any other servicing
needed must be performed by an
authorized service representative. Do
not attempt to service the unit
yourself.
Product Specifications
Model No.: DR-968
Voltage: 120V, 60Hz
Current: Maximum continuous draw:
12.5 amps
Output: 5200 BTUs
Power: 1500 Watts
Turbo Fan: Multi-blade; Low Noise
Figure 2 Figure 1