Full Product Manual

CAUTION: This appliance is not intended
for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
SAVE THESE
INSTRUCTIONS
Operating Instructions
1. Plug the power supply cord into a
grounded wall outlet. (120VAC,
60Hz).
Important: This heater comes with a
grounded (three-prong) plug. The
grounded plug must be used with a
grounded outlet. Do not use an
adapter in a two-slot wall outlet unless
the ground plug of the adapter
properly connects to a building ground.
Using the heater without a properly
grounded outlet or adapter could
result in an electric shock hazard.
The cord has a plug as shown at A in
the following figure. An adapter, as
shown at C, is available for
connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
2. TURNING THE HEATER ON
To turn the heater ON, press the
POWER button; the power LED
will turn on. Next press the MODE
button; the heat setting will be set
to AUTO. Press the MODE button
again to set to HIGH. Press the
button a third time to set to LOW.
Press the button a fourth time to
turn the heater OFF.
3. TURNING THE HEATER TO
STANDBY OFF To turn the
heater to Standby OFF, press the
Standby OFF button. The heater
will shut off but the fan will continue
to run until all the heat has been
expelled. The heater will turn off
automatically and is set to Standby
mode. If you are not going to use
the heater for a long time, press
the POWER button to fully shut
down the heater. The power LED
will turn off.
4. SETTING THE THERMOSTAT
Press the MODE button, and set to
AUTO mode to engage the
automatic thermostat.
5. SETTING THE TEMPERATURE
To set the desired temperature:
Press the button once
until the numeric temperature starts