Use and Care Manual

11
 TURNING THE HEATER ON
To turn the heater ON, select ON position on the ON/OFF rocker
switch. The power indicator light will turn on and display the
room temperature.
The default temperature setting is 70°F. If you select Inside
Thermostat and the room temperature is lower than or equal to
68°F, the heat function on the heater will engage on HIGH mode
and will turn off when the room temperature is higher than or
equal to 72°F.
 SETTING THE TEMPERATURE
To set the desired temperature:
Press the + button until the temperature display starts flashing.
Press button again to increase the temperature or the - button to
decrease the temperature.
After setting the desired temperature, press the MODE button to
HIGH or LOW. When the ambient room temperature drops 2°F
below the set temperature, the heater will turn on and begin
heating the room on HIGH or LOW (depending on the setting).
The heater will turn off once it senses the room temperature to
be 2°F above the set temperature.
Note: If WALL THERMOSTAT is selected on rocker switch, only
the external thermostat on the wall can control the heater’s
temperature setting.
 SETTING THE TIMER
Press the TIMER button until Set Time starts flashing. The
default value is 3 hours.
Press the “+” button to increase the set time or the “–” button to
decrease the set time. The timer can be set from 1 to 12 hours.
The timer will set and execute after the LED display stops
flashing. The heater will shut OFF automatically when the set
time is reached.
To turn the timer OFF, press the TIMER button, and then
pressing the “–” button to set the time to 0. The timer feature will
turn off when the LED stops flashing.
.