Use and Care Manual

WARNING - The heater must be properly installed before it is

used.

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC

FLASH:

 Apply appropriate personal protective equipment (PPE) and

follow safe electrical work practices. See NFPA 70.

 A circuit breaker must be installed and serviced only by

qualified electrical personnel.

 Always use a properly rated voltage sensing device to

confirm power is off.

The Select switch on the heater is only for function

selection. Use circuit breaker as power ON/OFF for the

heater. The circuit breaker is to be installed by a

certified/licensed electrician and should be located in

line of sight from the heater location or should be

capable of being locked in open position. Follow the

operating instructions to reduce the risk of fire, electric

shock, injury, or death to persons.

 Switch on the circuit breaker.

 Insert the batteries into the remote control as shown below:

NOTE: Remove the batteries if the remote control is not to be used

for a month or more. Batteries left in the remote may leak and cause

damage.

DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX

ALKALINE, STANDARD (CARBON-ZINC) OR RECHARGEABLE

(NICKEL-CADMIUM) BATTERIES!

OPERATING INSTRUCTIONS