Warranty

5
WARNING: All wiring must be installed by a certified/licensed
electrician.
The heater must be grounded in accordance with applicable national
and local building codes.
WARNING: To reduce the risk of fire, do not store or use gasoline or
other flammable vapors and liquids in the vicinity of the heater.
All wiring procedures and connections should be in accordance
with applicable national and local codes.
NOTE: Compatible with a 240V Line Voltage Double Pole Wall
Thermostat. Must be installed by a certified/licensed electrician.
Before installation:
Disconnect the main supply connection.
Supply cables should be 8 AWG (8.3 mm
2
) copper wires.
The heater must be connected to an individual branch circuit protected
by a 40 Amp circuit breaker only.
Supply cables must be equipped with a dual pole circuit breaker rating
at least 240V 40A/pole as main cutoff switch of power connection to the
heater.
Tools/ Materials Needed (Not Included):
·Regular Screwdriver Set
·
Spanner
·Impact Drill with 12mm Drill Bit
Recommended Accessories:
·
DR-001: Thermostat
Unpacking Contents:
·Heater
·
Owner's Manual
·
Warranty Card
·Heater Handle
·Mounting Bracket
·
Tilt Adjustable Knob x 2
·
Remote Control
·Battery x 2
INSTALLATION INSTRUCTIONS