Warranty

15
 Insert the batteries into the remote control as shown below:
NOTE: Remove the batteries if the remote control is not to be used
for a month or more. Batteries left in the remote may leak and cause
damage.
DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX
ALKALINE, STANDARD (CARBON-ZINC) OR RECHARGEABLE
(NICKEL-CADMIUM) BATTERIES!
 TURNING THE HEATER ON
To turn the heater ON, switch on the circuit breaker, press the
ON/OFF rocker switch to ON position, press the POWER button
on the remote, the power indicator will turn on and display the
room temperature.
 SETTING THE TEMPERATURE (with the remote control)
Note: You need to select the thermostat to INSIDE THERMOSTAT
and then set the desired temperature:
Press the + button until the numeric temperature starts flashing.
Press button again to increase the temperature or the – button to
decrease the temperature.
The heater will run on heating when the room temperature is equal
to or lower than the setting temperature - 2℉, and will turn off when
the room temperature is equal to or greater than the setting
temperature+2
℉
.
The factory setting temperature is 70℉, if the room temperature is
lower or equal to 68℉, the heater will run out heating and will turn off
when the room temperature is higher or equal to 72
℉
.
Note: If you set the thermostat switch to WALL THERMOSTAT,
press the + and - button cannot set the temperature, the heater
will run in ON or OFF heating according the wall thermostat
setting temperature.