Warranty

16
 Insert the batteries into the remote control as shown below:
NOTE: Remove the batteries if the remote control is not to be
used for a month or more. Batteries left in the remote may leak
and cause damage.
DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX
ALKALINE, STANDARD (CARBON-ZINC) OR
RECHARGEABLE (NICKEL-CADMIUM) BATTERIES!
 TURNING THE HEATER ON
To turn the heater ON, press the ON/OFF rocker switch to ON
position, the power LED will turn on and display the room
temperature.
The factory setting temperature is 70℉, If you set the
thermostat switch to Inside Thermostat, and the room
temperature is lower or equal to 68℉, the heater will turn to
High mode and will turn off when the room temperature is
higher or equal to 72℉.
 SETTING THE TEMPERATURE (with the remote control)
Note: You need to set the thermostat to INSIDE THERMOSTAT
and then set the desired temperature:
Press the Thermostat button, and then press the + button to
increase the temperature or the -button to decrease the
temperature.
You can also press the + button until the numeric temperature
starts flashing. Press+ button again to increase the
temperature or the - button to decrease the temperature.
After setting the desired temperature, the heater will run on
heating when the room temperature is equal to or lower than