Instructions / Assembly

Table Of Contents

4 | P a g e

Attention:Digital display position should be on left for correct installation direction

1. Mark the locations using the provided dimensions in Fig - 1a and using the holes on the L-

shaped bracket as a guide. Make sure the distance between 2 L-shaped brackets is 35mm/1.38”.

Mounting Height: maintain at least 2.4m / 7.9 ft distance between the heater and the floor.

2. Drill holes with a smaller diameter drill bit than the plastic anchor (H2) as shown in Fig - 2a.

3. Insert the pointed end of the plastic anchor (H2) into the holes as shown in Fig - 3a, tap the

anchor with a hammer until the anchor is flush.

Fig - 1a

4 x Hole smaller

than the plastic

anchor

Fig - 2a

H2 H2

4 x Plastic anchors flushed into 4 x holes

Fig - 3a

1.1 "

1.38 "