Instructions / Assembly

11 | P a g e
Caution:
When the appliance is not operated for a long period of time, cleaning or maintenance is
conducted or when the location of the heater is changed, the heater should be turned to OFF and
unplugged from the electrical connection.
Periodic inspection and removal of dirt and contaminants will ensure that equipment can be
operated safely.
Troubleshooting
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working
3. Error code shows on display
E1 Error on Display: Control unit overheat. Check installation clearances.
Let heater cool for 15 minutes and restart heater.
L1,2,3, shows in display, but no heat: Bulb isdamaged.Arrange for replacement bulb with local
dealer.
Factory reset procedure: With the power disconnected, press and hold the button on the heater
and then plug in the power cord into power outlet. Continue to hold the button for 30 seconds
and then let go. Unit will reboot and reset to factory setting.
MAINTENANCE
Attention! Careful and regular maintenance of your heater considering our instructions assume
great importance so as to attain a long efficient operation of your appliance.
1. Check the cleanliness of the Reflector and IR-Filament at least once a month. If necessary,
apply cleaning and maintenance instructions.
2. The number of checks may be increased considering the amount of the dust in the
environment.
3. Check the deformation of the Reflector, Wire and Frame visually while cleaning the appliance.
In case of deformation, contact service team.
4. Check the Power Cord and Plug visually while cleaning the appliance. In case of deformation,
contact service team.
CLEANING
Regular and careful cleaning helps your infrared heater operate efficiently for many trouble-free
years. To clean your heater, follow steps below:
1. Unplug the power cord for your safety before cleaning your appliance.
2. Make sure the heater is cool before continuing.
3. To keep the heater clean, the outer housing may be cleaned with a soft, damp cloth. You may
use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. (CAUTION: DO NOT
let liquids enter the heater).
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean the
heater. This may cause damage or deterioration to the surface of the heater.