Installation Guide

7 of 7
CAUTION:
Do not attempt to
remove the Pivot
Bolt during tilt
adjustments!
Removal could
lead to serious
personal injury or
death. Adjustments
are made with the
Pivot Bolt
hardware loosened
but in place.
CAUTION:
This is a two
person activity.
As the Pivot Bolt is
loosened and the
Support Bar
hardware is
removed, the rack
is heavy and
unstable. The rack
must be held in
place by one
person while the
second person
loosens and
removes the
hardware and then
re-installs/tightens
the hardware back
in place. Failure to
do so could lead
to serious
personal injury
and damaged
components.
Loosen
Pivot Bolt
Remove
Support Arm
Hardware
(upper hardware only)
Elevation Set Points
Strongback
Support
Bar
65°55° 45° 35° 25° 15°
Figure 6-1: Preparing to Adjust the Tilt Angle
Figure 6-2: Setting the Tilt Angle
Assembly Instructions, Top-of-Pole Mount for 3 Modules (TPM3) For Module Types A, B, & C (Version 2, Rev B)