User manual

52
DPMS XPQ User Manual
Energy Parameter setting
Pressing H and E simultaneously under the metering data display mode will
enter the energy settings page. The key operation is the same as in other
setting pages. You need to press H and E simultaneously to exit this mode.
The following table shows you how to set it:
01: TOU can be forbidden in application.
02: TOU time setting is complex, the meter has a default
when it leaves the factory. You can use the default or set it
yourself.
03: Energy can be reset by writing registers one by one
or writing “0” to them all at one time. TOU and real time
energy can be reset respectively.
04:“nature” means balance at the end of a month, “assign”
means balance at an assigned time every month. TOU
balance means to end the accumulation of the energy in
the current balance month and begin to accumulate the
energy in a new balance month.
05: When “assign” is selected, the time is to be set here,
format is dd:hh:mm:ss.
06: Copy the real time energy and TOU energy of current
month to the freezing memory. There are two modes.
“Assign” means pointing a time to freeze, “at once” means
freezing right now. If you select the “assign” mode, you
need to set the time on the 8th screen skipping the 7th; if
you select the “at once” mode, you need to nish the 7th
screen in order to execute the order.
03 : Real tim e ener gy
reset sel ection
04 : TOU balance m ode
selecti on
05 : TOU balance ti m e
setting
01 : TOU ener gy enabl e
02 : TOU setting reset to
defaul t
V/A
V/A
V/A
V/A
V/A
Access code page
E
H
+
06 : Ener gy freezing
mode selection
V/A