User manual

14
DPMS XPQ User Manual
The meter should be installed in a dry and dust free environment and avoid
heat, radiation and high electrical noise sources.
Maximum Altitude: 2,000m
Site Requirement: Indoor Use
Installation Steps
Normally, meters are installed on the panel of switch gear.
1. First, cut a square hole on the panel of the switch gear. The cutting size
is in g 2.3 Unit (mm)
Fig 2.3 Panel Cutting
2. Second, remove the clips from the meter and insert the meter into the
square hole from the front side.
Fig 2.4 Put the meter into the square hole
Cut
panel
90±
0.5
0.0
90±
0.5
0.0