Operations Manual

FUNCTION CHECK
SAFE Note: Remove magazine and make sure your rifle is unloaded and there is
no ammunition in the chamber. Point in safe direction. Pull charging handle to
rear and release. Place on safe. Pull trigger. Hammer should not fall.
FIRE Note: Remove magazine and make sure your rifle is unloaded and there is
no ammunition in the chamber. Point in safe direction. Place selector on fire.
Pull trigger and hold to rear. Hammer should fall. Pull charging handle to rear and
release. Release trigger and pull again. Hammer should fall.
SAFETY FEATURES
The following sections contain caliber specific information.
Please open to the section relevant to your particular rifle’s
caliber. If you are unsure of the caliber of the rifle, the caliber
marking can be found on the barrel of the rifle, immediately
in front of the gas block on the bottom of the barrel.
6
“SAFE”
Rifle will not fire. Selector lever cannot
be on safe unless rifle is cocked.
Always place on SAFE when loading
and unloading.
“FIRE”
Rifle will fire one round each time the
trigger is pulled.
Disconnector
The disconnector, a part of the firing mecha-
nism, prevents the firearm from firing full
automatic. As the hammer is cocked after
each shot the disconnector holds the ham-
mer until the trigger is released. When the
trigger is released, retention of hammer
passes from disconnector to trigger ready
for the next shot.
Firing Pin Collar
The bolt carrier assembly, located within the
upper receiver, is designed to prevent the
firing pin from striking a cartridge until the
bolt is locked to the barrel.
Everyone should read page 36 for additional information
pertaining to the Three Year Limited Warranty and returns!