Operations Manual

.223 CALIBER
MAINTENANCE
13. With a punch, remove the extractor
pin from the bolt assembly.
14. Remove the extractor and spring.
DO NOT remove the spring from
extractor.
15. Press top of extractor spring rubber
tip to test spring function.
16. To remove handguards, push delta ring towards receiver while pulling up on half of
the handguard. Repeat process for other half of handguard.
NOTE: Do not strip your firearm further than previously described.
If additional maintenance in necessary consult a competent gunsmith.
Your rifle is now field stripped for cleaning.
To reassemble repeat procedure in reverse order.
13
9. Remove bolt cam pin.
11. Remove bolt assembly
from carrier
8. Drop firing
pin out rear
of bolt
carrier.
GIVE C A M PI N A1/4
TURN AND LIFT OUT
CATCH
IT!
13. Remove
extractor pin
14. Remove extractor
and spring.
15a. Press in buffer, depress
retainer and release buffer
15b. Remove buffer
and spring
DON’T SEPARATE SPRING
FROM EXTRACTOR
USE PUNCH
BUFFER
RETA INER
HALT
FURTHER DISASSEMBLY
SHOULD ONLY BE PERFORMED
BY THE FACTORY (DPMS)