Data Sheet

Page 2 of 3
4017B, 4017B Shotgun Microphone
Directional characteristics:
Supercardioid, lobe-shaped
Principle of operation:
Pressure gradient, with interference tube
Cartridge type:
Pre-polarized condenser
Frequency range:
20 Hz to 20 kHz
Frequency range, ± 2 dB:
70 Hz to 20 kHz, permanent third order high
pass filter at 50 Hz
Sensitivity, nominal ± 2 dB at 1 kHz:
19 mV/Pa; -34.4 dB re. 1 V/Pa
Equivalent noise level, A-weighted:
Typ. 14 dB(A) re. 20 µPa (max. 15 dB(A))
Equivalent noise level, ITU-R BS.468-4:
Typ. 25 dB (max. 26 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94
dB SPL):
Typ. 80 dB(A)
Total Harmonic Distortion (THD):
< 1 % up to 133 dB SPL peak
Dynamic range:
Typ. 119 dB
Max. SPL, peak before clipping:
152 dB
Filters:
High boost: +4 dB at 8 kHz. Low cut: First
order filter, below 120 Hz
Output impedance:
< 150 ohm
Cable drive capability:
100 m (328 ft)
Output balance principle:
Signal balanced
Common Mode Rejection Ratio (CMRR):
> 40 dB
Power supply:
48 V Phantom power (± 4 V)
Current consumption:
4.5 mA
Connector:
XLR-3M. Pin 1: shield, Pin 2: signal + phase,
Pin 3: signal - phase
Color:
Matte black
Weight:
68 g (2.4 oz)
Microphone diameter:
19 mm (0.75 in)
Capsule diameter:
19 mm (0.75 in)
Microphone length:
212 mm (8.3 in)
Output voltage, RMS:
> 1.8 V
Polarity:
+V at Pin 2 for positive sound pressure
Temperature range:
-40 °C to 45 °C (14 °F to 113 °F)
Relative Humidity (RH):
Up to 90 %
Diagrams
4017B, 4017B Shotgun Microphone
On- and off-axis responses of 4017B measured at 60 cm (23,6 in)
On- and off-axis responses of 4017B measured at 60 cm (23,6 in)
Frequency responses of switching filters on 4017B
Frequency responses of switching filters on 4017B