Manual
www.sprayfoamatdow.com
www.sprayfoamatdow.ca
Printed in U.S.A.
a proud partner of
®™Trademark of The Dow Chemical Company (“Dow”) or an affiliated company of Dow
Habitat for Humanity is a registered service mark owned by Habitat for Humanity International
determining whether products and the information in this document are appropriate for Customer's use and for ensuring that Customer's workplace and disposal practices are in compliance with applicable laws and other
government enactments. The product shown in this literature may not be available for sale and/or available in all geographies where Dow is represented. The claims made may not have been approved for use in all countries
or regions. Dow assumes no obligation or liability for the information in this document. References to “Dow” or the “Company” mean The Dow Chemical Company and its consolidated subsidiaries unless otherwise expressly
or goggles. Provide adequate ventilation or wear proper respiratory protection. Contents under pressure.
or safety glasses. Provide adequate ventilation or wear proper respiratory protection. Contents under pressure.
Building and/or construction practices unrelated to building materials could greatly affect moisture and the potential for mold formation. No material supplier including Dow can give assurance that mold will not develop in
any specific system.
Cleanup
can be dissolved with GREAT
STUFF PRO™ Gun Cleaner.
Cured foam must be mechanically
removed or allowed to wear off in
time.
install a can of GREAT STUFF
PRO™ Gun Cleaner to the foam
dispensing gun and spray until
all foam is blown out of the
dispensing gun and only cleaner
is visible (approximately half the
can of cleaner will be used). Allow
the gun to sit for several minutes
and repeat with a second flush.
mounted on the foam dispensing
gun. This will dissolve the lip
seals inside the gun and render
it useless. Foam escaping at the
handle or trigger indicates a faulty
seal. If this happens, the gun
should be replaced. If the foam
dispensing gun has not been
cleaned, add a new can of GREAT
STUFF PRO™ Gaps & Cracks
immediately. If left without a can
attached, exposure to air and
moisture will cause the foam in the
gun to cure.




