Operating Guide

Section 3
Operating Instructions
How to prepare and use your Froth-Pak
™
Kit.
Froth-Pak
™
Kit contents
Froth-Pak
™
Kit 115, 160, 120 200 and 210:
2 Tanks of chemical (1 ISO,1 POLYOL)
1 Insta-Flo
™
Dispenser and Hose Assembly
1 Assortment Anti-Crossover Nozzles
1 Petroleum jelly packet
1 Operating Manual
Froth-Pak
™
Kit 620 and 650:
Chemical tank A (ISO) - boxed
Chemical tank B (POLYOL) - boxed
Gun / Hose Assembly Kit - boxed
• 1 Insta-Flo
™
Dispenser and Hose Assembly
• 1 Assortment Anti-Crossover Nozzles
• 1 Petroleum jelly packet
• 1 Operating manual
• 1 Wrench (5/8”)
Getting the kit ready
1. For users of 115, 160, 120 200 and 210 kit :
The Insta-Flo
™
Dispenser/Hose Assembly is connected
to the chemical tanks. Lift the Insta-Flo
™
Dispenser/
Hose Assembly from the box and fully uncoil hose.
2. Free the perforated section in upper section of the box
(near the locking tab that retained the lid), and bend it
down to allow the hoses to enter into the two cutouts
provided. (See figure 1)
3. Apply a coating of petroleum jelly to the inside face of
the Insta-Flo
™
Dispenser. This makes cleaning of the
dispenser face much easier and extends the effective
life of the Insta-Flo
™
Dispenser. (See figure 2)
4. For users of the Froth-Pak
™
620 and 650 kit:
Using the wrench provided in the Gun / Hose Assembly
Kit, tighten the hose assemblies for both “A” and “B”
valves until both are tight. The wrench is intentionally
designed to warp or bend if excessive pressure is
applied. Apply a coating of petroleum jelly to the inside
face of the Insta-Flo
™
Dispenser. (See figure 3)
5. Purge the system into a waste container by activating
the trigger of the Insta-Flo
™
Dispenser. When streams
are equal, release the trigger, clean the chemical from
the dispenser face with a clean rag, and reapply
petroleum jelly. (See figure 4)
6. Select an Anti-Crossover Nozzle and insert firmly
into the front of the Insta-Flo
™
Dispenser. Be sure the
dispenser clips the nozzle firmly in place.
6
WARNING
Before using Froth-Pak
™
kits .please read and follow ALL
instructions in this manual. and the SDS