Sense Smoke Control Kit Instructions

ManualsBrandsDovre ManualsWood Burning StovesSense 203 Wood Burning Stove

Dovre Sense

Smoke Control Kit

Additional Installation and operating

Instructions for use in Smoke Control Areas

PM1070 Issue 2 (July 2014)

These instructions for fitting and operating the

Smoke Control kit must be read in conjunction with

the following Installation Instructions.

Ref: Dovre Sense 03.27151.000 07.-2014

Summary of content (8 pages)

PAGE 1
Dovre Sense Smoke Control Kit Additional Installation and operating Instructions for use in Smoke Control Areas These instructions for fitting and operating the Smoke Control kit must be read in conjunction with the following Installation Instructions. Ref: Dovre Sense 03.27151.000 07.
PAGE 2
Use General Lighting 1 1 You can check whether the flue has enough draught by lighting a ball of paper above the baffle plate. A cold flue often does not have enough draught and consequently, some smoke may escape into the room instead of up the chimney. By lighting the fire in the way described here, you can avoid this problem. 2. Stack two layers of logs crosswise. These instructions apply to the Dovre Sense products listed when fitted with a Smoke Control kit.
PAGE 3
Use Compact stacking Air Control Closed Compact stacking will make the wood burn slower as wood can only reach the outside of the fire. This will cause the fire to smoulder and produce smoke. Open Refuelling the Appliance 1 Open the air control fully and burn for a few minutes before refuelling. Do not fill to more than capacity. Refuelling on to a low fire bed If there is insufficient burning material in the firebed to light a new fuel charge, excessive smoke emission can occur.
PAGE 4
Use 5 When in use, burning the appliance at high output for a short period also reduces tars and creosote. 6 When running the appliance: Refuel little and often for clean, efficient burning. 7 Wood burns best on a bed of ash. A bright and clean firebox indicates the appliance is burning well. Controlling the air Advice Never burn wood with an open door. If you frequently have low intensity fires, tar and creosote may be deposited in the chimney. Tar and creosote are highly combustible substances.
PAGE 5
Installation These instructions cover the fitting of the Smoke Control Kit Parts List 3 Appliance Smoke control kit Part No. Dovre Sense 100 Smoke Control Bracket DV-SENSESZKIT Dovre Sense 103 Place the Smoke Control bracket on top of the air control slider. The fold should face downwards.
PAGE 6
Installation An appliance modified for Smoke Control can be recognised in the following manner: The air control has restricted movement and can not be shut completely (1). 1 2 1 2 For appliances that have not been fitted with a Smoke Control kit the air control can be shut completely (2).
PAGE 7
PAGE 8
The Clean Air Act 1993 and Smoke Control Areas Under the Clean Air Act local authorities may declare the whole or part of the district of the authority to be a smoke control area. It is an offence to emit smoke from a chimney of a building, from a furnace or from any fixed boiler if located in a designated smoke control area.