250 with Smoke Control Installation & User Instructions

9
10. Extended Burning
10.1 It is possible to get the appliance to burn for extended
periods of time. In order to do this:
—De-ashpriortonalrefuelling.
— Burn new fuel at a high temperature for a few minutes
before adjusting the Primary Air Control.
— Set air controls to low combustion settings.
This will gradually blacken the glass but it will clear when
operated at a high temperature for a short period.
— Use smokeless fuel or small, thick logs depending on
fuel desired.
NOTE: It is not recommended to extend the burning
period in Smoke Control Areas. This process increases
the amount of smoke produced.
 AnappliancewithoutaSmokeControlkitttedwillburn
longer than an appliance that complies to the restrictions of a
Smoke Control Area.
11. Ash Removal
Do not allow ash to build up as it may cause damage
and adversely effect the performance of the appliance.
Warning: Ash can remain hot long after appliance has
been in use.
11.1 All Models:
— De-ash the appliance before filling with new fuel. Do not
allow ash to build up on the underside of the grate as this
can cause premature failure.
— Riddle with the tool provided, see Diagram 11.
— Leave a layer of ash to start the new fire on. Wood burns
best on a bed of ash (approx. 25mm (1") deep).
Riddling Handle
11
— Move the Riddling Tool backward and forward 3 or 4 times
to remove the ash. Do not force the handle beyond its
natural stop point. The ash will fall into the ashpan.
— Open the door, see Diagram 12.
Door Handle:
Pull forward to open
12
Warning: Ash can remain hot long after appliance has
been in use.
Using gloves, carefully remove ashpan using tool supplied,
see Diagram 13. Ensure the tool is fully engaged before
operation. Practise this technique before hand with a cold
ashpan.
13
— Place the ash into an Ash Caddy (Part No. 4227) or other
suitable container.
— De-ash at least once a week.
Do not place hot ash in a container made from plastic or
any other combustible material.
12. Over-Firing
12.1 Do not over-fill with fuel or run at high temperatures for long
periods or over-firing can occur.
WARNING: DO NOT OPERATE THE APPLIANCE WITH
THE PRIMARY AIR CONTROL OPEN OR AIRWASH
ON MAXIMUM FOR LONG PERIODS OF TIME AS
THIS COULD CAUSE OVER-FIRING AND MAY CAUSE
PERMANENT DAMAGE.
12.2 Over-firing can cause permanent damage to the
appliance and invalid the product warranty.
*Registered on the Competent Persons Scheme (GB
only) see page 29/ INFO (Republic of Ireland).
User Instructions/ Care & Maintenance