WOOD STOVE 500CB /510GH INSTALLATION INSTRUCTIONS AND OPERATING MANUAL 500GH-510GH 1 03.27848.
Table of contents page Foreword ............................................................................................................................3 1. Introduction.................................................................................................................3 2. Safety............................................................................................................................3 3. Installation guideline .............................................................
Foreword The Installation Manual and Operators Instructions must accompany this appliance. As well as instructions for installation and information about use, you will also find advice concerning safety and maintenance. Please read this booklet carefully before installation and before firing the unit. Save this booklet and pass to any subsequent user who can also profit by it. 1.
3. Installation guideline 3.1. Preparatory measures The stove should be hermetically connected to a well-functioning chimney, sufficiently enclosed to keep combustible materials (floor and walls) at a distance, and should be installed in a room with sufficient ventilation. Please inform about national or local norms and regulations concerning this subject. Your distributor will give y ou the necessary advice.
• • way that wind will not hinder, but promote the smoke flow. Especially if the flue runs through unheated rooms or outside the house, further insulation is necessary. Metal chimneys, or parts of the chimney outside heated rooms should always have double -walled, insulated flues. The part of the chimney outside the roof should always be insulated. The chimney should be high enough (at least four metres) and should end in a zone that is clear of nearby buildings, trees or other obstacles.
3.2. Preparing the stove Please inspect the stove for damage caused during transport immediately after delivery and notify your distributor in case there are any defects. Do not put the stove into operation in the meantime. In order to avoid damaging the stove during installation and to make handling of the stove easier, it is recommended to remove previously all loose parts (fire-resistant bricks, grille, ashtray, ...) from the stove.
3.2.3. Assembling the “cold handle” ( Assemble the different parts of the handle, i.e. a screw M8x50, a wooden handle, a hook and a nut, as indicated on the sketch. For some appliances, this handle can be hooked on a handle holder which can be mounted on the base plate of the stove, near the left front leg. 3.3. Finishing When the stove is placed in the final position and hermetically connected to the chimney, you can replace all of the loose parts. Your stove is now ready for use.
4. Instructions for use 4.1. Fuel The only suitable fuels for this stove are wood and brown coal briquettes. No other fuels are allowed to be burnt, as they can inflict serious damage to your stove. Do not burn any treated wood either, such as scrap wood, dyed wood, impregnated or preserved wood, plywood or chipboard. The fumes of these, as of synthetic materials, old papers and household waste, are highly polluting for both your stove and your chimney, and for the environment.
Always open the filling door slowly and for a short space of time. Before filling up, the charcoal bed should be carefully spread open. Check whether the coals are glowing enough just behind the log retainer, so that the added fuel will immediately catch fire. If necessary you can open the lower air slide for a while. Open stacking will make the logs burn very intensely, as the oxygen can easily reach every part of the fire. This method of stacking is applied when burning wood for a short while.
5. Maintenance It takes only little effort to keep your stove in good condition. Regularly check whether the sealing cord still closes the doors tightly enough. The painted or enamelled cast iron mantle can be cleaned with a moist, soft cloth, when it is almost cold. Minor paint damage can be touched up with a can of spray paint. Your dealer can supply you with the correct spray product. For enamel damage, small repair kits of appropriate colour are available with your dealer.
Annex 1 : technical data sheet Model 500GH / 510GH 8 kW Nominal heat output Advised combustibles Wood and brown coal Maximum length of logs 40 cm (20 cm back) ) % CO 0.11 % Efficiency 83 % 5.6 g/s Flue gas mass flow 315 °C Flue gas temperature 0.13 mbar Minimum draught 150 mm Flue connection (diameter) Weight 500GH-510GH 130 kg 11 03.27848.
Annex 2 : dimensions 500GH 500GH-510GH 12 03.27848.
CE-conformiteitsverklaring Declaration de conformité CE EC Declaration of conformity Konformitätserklärung CE Notified body: 1625 Wij, Nous, We, Wir, Dovre nv, Nijverheidsstraat 18, B2381 Weelde, verklaren bij deze dat de houtkachel 500GH/510GH conform is volgens de EN 13240. déclarons que le poêle 500GH/510GH est conforme au norme EN 13240. declare that the wood stove 500GH/510GH est in conformity with the EN 13240. Erklären daß das Produkt 500GH/510GH entspricht EN 13240. Weelde, 16.09.
