Manualshelf

User Manual

ManualsBrandsDoug Fleenor Design ManualsAccessories for electricalPRE10-P
123456
Page 6 of 6
PLAYBACK OF PRESETS
Presets can be played back in one of two ways, a crossfade to a static preset or an autofollow of all ten presets. A crossfade
is a change from the current preset to the newly selected one. The time taken to fade from the current preset to the new preset
is taken from the newly selected preset. Once the fade has completed it will remain at that current preset (static) until another
preset is selected. W hen the autofollow method of playback is used once the fade time of the currently fading preset is
completed the next preset is automatically selected.
To begin a crossfade between presets, momentarily press the preset select button of the preset you wish to play.
To begin autofollow of all ten presets, press and hold the preset select button of preset number 1 (approximately 5
seconds) until all the LEDs flash once. Once the fade time of a preset is complete, the next preset will be selected
automatically. When preset number 10(OFF) has been reached the next preset to be selected will be preset number 1.
To exit autofollow momentarily press any preset select button.
Note:
! If a static preset is playing at the time power is lost Preset 10 will return to that preset when power is
restored. The fade will begin with all 512 channels at 0% and fade up in the time recorded to that preset.
! If the Preset 10 was in autofollow playback at the time power was lost, the Preset 10 will resume
autofollow playback beginning with preset number 1.
! To bypass unused presets In autofollow enter the time as 999 seconds. This means the longest
autofollow fade time is 998 seconds.
PRESET NUMBER 10 (OFF) - SPECIAL FUNCTION
When the levels stored in preset number 10(OFF) are all zeros a special function is enabled. W hen preset 10(OFF) is
selected and the crossfade has completed the Preset 10 will stop sending DMX512. By ending DMX512 transmission,
many moving lights and dimming systems will enter their standby mode. This feature can be disabled by recording any
non-zero level on any channel into preset number 10(OFF).