User Manual

Page 5 of 6
RECORDING PRESET CROSSFADE TIME
A crossfade is a fade where the new preset levels entirely replace the previous levels. Each of the ten presets can have its
own unique crossfade time. Crossfade times default to two seconds.
Note:
! Crossfade times range from a minimum of 0 seconds to a maximum of 999 seconds (16.65 minutes).
! Crossfade times can not be set while the Preset 10 is locked out (RED LED is illuminated).
To enter a different crossfade time:
1. Disconnect the Preset Ten from any DMX512 source.
2. Press the button of the preset you wish to edit. The GREEN preset indicator LED will illuminate.
3. Using a small blunt object (i.e. paper clip), depress the recessed FADE TIME button located below preset number 5.
The indicator LED, adjacent to the preset you selected to edit, will now flash. You will have ten seconds to set the
crossfade tim e before. If you decide after depressing the FADE TIME button that you do not wish to make an edit
simply wait ten seconds to exit or press the FADE TIME button a second time. No changes will have been made
4. Enter the time in seconds using the PRESET SELECT buttons. Use PRESET SELECT button 10(OFF) to enter a
zero. (i.e. 120 seconds is entered by pressing PRESET SELECT button 1 followed by 2 then 10). The time setting
command is completed by one of three methods.
a. Enter a three-digit time. The third digit will complete the entry. The GREEN preset indicator LED will illuminate
steadily indicating success. A one or two digit time may be entered with leading zeros (i.e. five seconds as
005 or 10, 10,5).
b. Enter a one or two digit time followed by pressing the FADE TIME button. The GREEN preset indicator LED
will illuminate steadily indicating success.
c. Enter a one or two digit time and wait for ten seconds. The GREEN preset indicator LED will illuminate
steadily indicating success.