User Manual

Page 3 of 6
SETUP AND CONNECTIONS
The Preset 10 Portable should be installed between the console and DMX512 receiving devices. Typically, it should be
within arms length of the console operator.
Remove the cable connected to the output of the console. Use a short DMX512 cable to connect the output of the console
to the DMX512 input of the Preset 10 Portable. Connect the cable that was originally connected to the console to the
DMX512 output connector of the Preset 10 Portable. This inserts the Preset 10 Portable into the DMX512 signal path.
Plug the Preset 10 Portable power supply into mains power.
NOTE:
! The console will still operate normally when the Preset 10 Portable is not powered.
OPERATION
INDICATORS
RED LED
ON = RECEIVING DMX512
FLASHING = RECORD MODE
GREEN LED
ON = CURRENTLY SELECTED PRESET
FLASHING = TIME SETTING MODE SELECTED FOR THAT PRESET
ALL GREEN LEDS
FLASHING = LOSS OF DMX512 INPUT ALERT - PRESET 10 PORTABLE IS HOLDING THE LAST LOOK.
GREEN LED RED LED STATE
OFF OFF UNIT NOT POWERED
OFF ON
RECEIVING DMX512
PRESET PLAYBACK IS LOCKED OUT
OFF FLASHING
RECORD MODE ACTIVE
CURRENT LOOK W ILL BE STORED TO NEXT PRESSED PRESET
FLASHING OFF TIME SETTING MODE ACTIVE FOR SELECTED PRESET
ON OFF
PRESET 10 PORTABLE TRANSMITTING DMX512
NO DMX512 INPUT
When the primary console is powered ON your lighting system should function normally. The RED LED of the Preset 10
Portable will illuminate indicating that a DMX512 signal is present.