PRESET 10 ARCHITECTURAL OWNERS MANUAL Doug Fleenor Design 396 Corbett Canyon Road Arroyo Grande, CA 93420 (805) 481-9599 Software Version 2.
PRODUCT DESCRIPTION The Preset 10 Architectural is a lighting control station capable of storing up to ten presets. These presets are recorded by capturing the output of a DMX512 console. Each preset can then be assigned a unique fade tim e, from 0 to 999 seconds. Presets are recalled by pressing one of the buttons. System s can be created by using one or m ore stations and a power supply. The solid alum inum faceplate is designed to install over a standard single gang electrical box.
SPECIFICATIONS Connector: Connector pin out: Phoenix Contact MSTB series 5 position two part term inal block Model: MSTB 2,5/5-ST-5,08 Order Num ber: 17 57 04 8 (V) (C) (+) ( -) (C) Supply voltage “hot” Supply com m on (internally tied to DMX512 com m on) DMX512 data + DMX512 data DMX512 com m on Input/Output Circuit: ESD protected EIA-485 transceiver (LT1785) Indicators: Ten green preset indicator LEDs One yellow Fade Tim e LED One red Signal / Record LED User controls: Ten preset push buttons One
PRESET 10 ARCHITECTURAL - INSTALLATION WIRING INFORMATION Preset 10 Architectural is designed to use daisy-chain wiring topology. An alternative to the daisy-chain topology is the star topology. To create a star, a bidirectional isolated splitter (m odel BiDi8) is required. Also note that a system m ay contain m ultiple power supplies when voltage drop becom es a concern. Please give us a call if you have any questions.
PRESET 10 ARCHITECTURAL - SETUP FACEPLATE CONFIGURATION Each Preset 10 Architectural has four jum pers, JP1 through JP4, that select different m odes of operation. The factory default is to have all jum pers installed. JP1 W hen this jum per is installed on the MASTER faceplate recording of presets is enabled. W hen rem oved, the TIME and RECORD buttons are disabled. The position of JP1 on a SLAVE faceplate has no affect. JP2 W hen this jum per is installed the faceplate takes on the MASTER duty.
PRESET 10 ARCHITECTURAL - OPERATION INDICATORS GREEN LED ON = CURRENTLY SELECTED PRESET FLASHING = TIME SETTING MODE SELECTED FOR THIS PRESET YELLOW LED ON = PRESET FADE IS IN PROGRESS FLASHING = TIME SETTING MODE SELECTED RED LED ON = STATION LOCKED OUT / RECEIVING DMX512 FROM EXTERNAL CONSOLE FLASHING = RECORD MODE ACTIVE GREEN LED YELLOW LED RED LED STATE OFF OFF OFF UNIT NOT POWERED OFF OFF ON RECEIVING DMX512 PRESET 10 IS LOCKED OUT FROM TRANSMITTING OFF OFF FLASHING FLASHING FLASHING
RECORDING PRESET CROSSFADE TIME A crossfade is a fade where the new preset levels entirely replace the previous levels. Each of the ten presets can have its own unique crossfade tim e. Crossfade tim es default to two seconds. Note: ! Crossfade tim es range from a m inim um of 0 second to as m axim um of 999 seconds(16 Min., 39 Sec.). ! Crossfade tim es can not be set while the Preset 10 is locked out (red LED is illum inated). To enter a crossfade tim e: 1.
