Datasheet

Installation for Flex Tier Extension Models:
1 - Uninstall Extension Post
Detached Tier Extension from your Flex Stand and remove the Extension Post. Skip this step if Product
is new Post has not been previously installed.
3 - Install Pole Adapter
Using the (2) 3/4” Screws, attach the Pole Adapter to the end of the Height Extension Module and tighten
with 4mm wrench originally provided with your Tier Extension.
4 - Re-Install Extension Post
Use the original (2) Bolts (M6-80) to attach the Extension Post to the end of the Pole Adapter. You are now
ready to attach your Tier Extension to your Flex Stand. Follow directions provided with Tier Extension.
2 - Install Height Extension Module
Using the enclosed 5mm wrench, attach the Height Extension to the bottom of the Stand Pole with the
(2) enclosed bolts (M6-80).
Service & Support
t: 888.897.8869
e: [e-mail]