Operator`s manual
Table Of Contents
- Contents
- Figures
- Tables
- Safety
- Introduction
- Setting Up the 708-DS / 709-DS
- Operating the 708-DS / 709-DS
- Main Screen - Options
- Main Screen - Display Parameters
- Main Screen - Sample Temperatures
- Main Screen - Run
- Main Screen - Stop
- Main Screen - Drive Unit Up / Down
- Manual Drive Unit Up / Down
- Manual Sampling
- Main Screen - Manifold Up / Down
- Main Screen - Lock
- Main Screen - Unlock
- Main Screen - Remote Control
- Main Screen - Alarms
- Main Screen - Maintenance Due Icon
- Menu Screen - System Menu
- General 708-DS / 709-DS Conventions
- Agilent 708-DS / 709-DS Notifications
- Main Screen - Options
- Maintenance and Troubleshooting
- Index
82 708-DS / 709-DS Operator’s Manual
4 Operating the 708-DS / 709-DS
Menu Screen - Instrument
Menu Screen - Instrument Settings Screen 1
Table 6 Menu Screen - Instrument Settings Screen 1
Option Function
Tester ID A twelve-character field that helps identify the instrument. The Tester
ID is printed out with the other system information during a test.
Comm ID The address of the instrument on the communications bus. This address
is used by external host programs to communicate with the instrument.
The Comm ID may range from 01 to 99.
All Position Spin Allows the spindle to rotate regardless of the position of the drive unit.
This is useful when calibrating spindle speed as the spindle may rotate
while the drive unit is in its upper position. If this option is not checked,
the spindle only rotates when the drive unit is in its lowest position.