Operator`s manual
Table Of Contents
- Contents
- Figures
- Tables
- Safety
- Introduction
- Setting Up the 708-DS / 709-DS
- Operating the 708-DS / 709-DS
- Main Screen - Options
- Main Screen - Display Parameters
- Main Screen - Sample Temperatures
- Main Screen - Run
- Main Screen - Stop
- Main Screen - Drive Unit Up / Down
- Manual Drive Unit Up / Down
- Manual Sampling
- Main Screen - Manifold Up / Down
- Main Screen - Lock
- Main Screen - Unlock
- Main Screen - Remote Control
- Main Screen - Alarms
- Main Screen - Maintenance Due Icon
- Menu Screen - System Menu
- General 708-DS / 709-DS Conventions
- Agilent 708-DS / 709-DS Notifications
- Main Screen - Options
- Maintenance and Troubleshooting
- Index
Setting Up the 708-DS / 709-DS 3
708-DS / 709-DS Operator’s Manual 37
Figure 14 Affixing the Fasteners
Accessory Installation
1 Locate the appropriate accessories from the following list to be
configured with the Agilent 708-DS / 709-DS: evaporation covers,
Dosage Delivery Modules (DDMs), alignment posts, receptor shafts,
paddle shafts, basket shafts, and shaft locking collars.
2 If necessary, press and hold Drive to move the drive unit to its
fully raised position.
3 If applicable, insert a receptor shaft (spin on/off shafts only) into
each spindle location.
4 Slide an evaporation cover onto the shafts to be installed and insert
the shaft into each spindle location.