Installation Manual

8
2.3. Remove the camera from the enclosure or protective cover that comes with the system. In
some cases, the camera will not come installed in an enclosure. Attach the camera to the
mounting plate using 1/4-20 Cap Screw, split lock washer and flat washer. Torque to 28 in-lbs.
Use of a screw with a nylon locking patch (instead of a split lock washer) is recommended for
heavy systems in high vibration environments. Allow access to cable ports as necessary.
2.4. Loosen the two tilt adjustment screws using a 7/32” allen key. Swing the mounting bracket to
the other side of the enclosure to provide clear access to the cable gland and front opening.
Do not adjust tilt angle in a “partially tightened” state. Doing so can cause seizure of
the bracket system beyond repair. Always loosen the tilt adjustment screws until there is a
visible gap between both screw heads and the bracket prior to adjusting the tilt angle.