Installation Manual

22
5. BASH Installation
Install BASH enclosure at mounting location.
It is recommended that the system be mounted as high as practical for optimal viewing
and capturing the most data. Imaging the camera before and after or during pan/tilt
adjustments yields optimal results.
5.1. Loosen the two tilt adjustment screws until there is zero clamping force from the screws. There
should be a visible gap between the screw heads and the bracket prior to adjustment. Adjust
the tilt position so that camera lens is facing straight down towards the bracket and re-tighten
the two side bolts. This provides tool access to the mounting hole in the bottom of the bracket.
The bracket may also be completely removed for this step if preferred.