Installation Manual

3.3.3. Pass a 12VDC power cable through the sealing nut and into the other empty hole in the

internal rubber gland, bringing the cable into the enclosure.

3.3.4. Connect the leads of the power cable to the terminal block using a #1 phillips head screw

driver or smaller. Positive/red lead goes on the left side and negative lead goes on the

right.

3.3.5. Mount the combined camera and camera mounting plate back inside the enclosure by

screwing the 4x #6-32 screws and washers into the 4 mounting bosses. Bring camera

cables through the bottom opening of the mounting plate (if necessary) and establish

connections with the camera.